Thank you for purchasing an LED acrylic card from Anomaly Shop!

We’ll show you below how to replace the CR2032 battery from your LED card. If you find that this is too complicated, you can send in your card for service and we’ll make sure it is back to you in top condition.

 

Turn the card on its back and remove the 4 screws.
–
	Carefully lift the battery module. Make sure that the LED comes up cleanly and does not get stuck in the card.
–
Very gently pull the LED backwards, just a little bit, so that there is room to remove the battery.
–
	Push the battery up to remove it. Insert a fresh CR2032 battery. Carefully replace the battery module inside the card. Clean any dust that may have settled on the card. Place back and tighten the 4 screws.